ethernet software installation
installing the printer software on a networked computer
before installing
Before installing the printer software on a networked computer, verify the following:
●
The printer is set up and powered on.
●
The ethernet
hub
or
router
is powered on and functioning properly.
●
All computers on the network are powered on and connected to the network.
●
The
printer is connected to the ethernet network
.
If the printer was previously installed on a computer with a USB cable, disconnect the USB
cable from the printer. Use the printer software CD and follow the instructions below to
install an ethernet version of the printer driver on the computer.
installation steps
Follow these steps to install the printer software on a networked computer:
1. Insert the printer software CD in the computer's CD-ROM drive.
If the CD does not autoplay, then open the CD in Windows and double-click the
setup.exe
file.
2. Follow the onscreen instructions and use the following information to complete the
installation.
❍
Printer connection:
Connected via network
❍
Network setup:
Basic network setup for a PC or server
If the printer cannot be detected during the installation process, then
follow the
printer cannot be detected during software installation
instructions in
ethernet troubleshooting
.
3. After the installation has completed, follow the onscreen instructions to print a test page.
file:///C|/hun/ug_ethernet_install_dhcp_autoip_fs.html [12/17/2002 12:55:13 PM]
ethernet troubleshooting