connecting the printer to an ethernet network
Follow these steps to connect the printer to an ethernet network.
1. If necessary, set up the printer hardware.
For printer hardware setup instructions, see the
setup
poster that came with the printer.
2. Verify that the printer is powered on.
3. Connect the
ethernet cable
to an available port on the ethernet
hub
or
router
.
4. Connect the
ethernet cable
to the ethernet port on the back of the printer.
To prevent damaging the printer, do not use a phone
cord to connect the printer to an ethernet network,
and do not connect the printer to a phone jack.
5. Do one of the following:
if the link light is...
then...
Install the printer software on the network computers
.
file:///C|/hun/ug_ethernet_install_most_fs.html (1 of 2) [12/17/2002 12:55:13 PM]
connecting the printer to an ethernet network
Repeat steps 2-4. If the lights are still off, then verify the
following:
❍
The printer is powered on.
❍
The
hub
or
router
is powered on.
❍
All cable connections are secure.
❍
You are using an
ethernet cable
.
file:///C|/hun/ug_ethernet_install_most_fs.html (2 of 2) [12/17/2002 12:55:13 PM]